Take the measurements

Each dog is unique: its morphology, its gait, its musculature…

To ensure your accessory fits perfectly , is comfortable and safe, it is essential to take precise measurements .

This page has been designed to guide you step by step.
You will find simple explanations, diagrams and advice on how to measure your dog in the best conditions, so that the workshop can create an accessory that is truly adapted to its body and its daily life.

Take your time, follow the steps, and don't hesitate to contact us if you have any doubts!
The perfect fit starts here 🖤

📏 Required equipment
  • A flexible measuring tape
  • The subject to be measured, in a standing position

All measurements must be taken as close as possible to the skin , without excessive sizing or tightening .

⚙️ Scouting steps

Before measuring, locate the following anatomical landmarks :

  • The coasts and their outline, especially the last coast
  • The elbows
  • The tip of the sternum (front of the thorax)
  • The scapulae (shoulder blades)

These reference points serve as a basis for correctly positioning the harness measurements.

📐 Measures to take
  1. Neck circumference : Measure lower than the collar, at the point where the harness will rest.
  2. Chest measurement: Measure around the rib cage at the point where you want the harness to end.
    ➜ It is usually behind the elbows, at about 3 fingers to a hand's minimum distance.
  3. Back : Measure the length from the collar (between the two scapulae) to the chest circumference on the top of the back.
  4. Belly : Measure from the tip of the sternum to the ribcage, under the belly.
📸 Sending measurements

You can send your photos and/or videos of the measurements, clearly legible, by message to the Atelier (@atelier_des_toutous) or attach them when placing your order.

⚠️ Important points
  • Seek help if necessary to ensure fair measures are taken.
  • Always measure behind the elbows , at least 3 fingers away from your hand .
  • Never let the harness extend beyond the ribs : it should not go all the way to the lumbar region .
  • Check that all measurements are consistent and legible before sending.